![]() It may be necessary to open and close the "Configuration Manager Properties" to refresh the tabs.If the Configurations tab is blank, you can go to the Action tab and select "Machine Policy Retrieval & Evaluation Cycle" and then click on the Initiate Action button.Your main concern is that the second tab, Components, has been loaded correctly. (In case you need click to Repair the components, you'll need to login with your domain account). Note: It takes a while to show all the available actions. Make sure that under the Actions tab all the actions are listed as shown below.Make sure that under the Components tab Status shows as installed or enabled.Launching SCCM will give you the following set of tabs:.Microsoft Endpoint Configuration Manager can be located at the Control Panel (Windows 10):.Not completing the last step of post-config causes SCCM to not install properly. In preparing a Windows-based client for use, you will need to check if all entries of SCCM are loaded on the client machine after post-config has completed. Microsoft Endpoint Configuration Manager provides remote control, patch management, software distribution, operating system deployment, network access protection, and hardware and software inventory. Microsoft Endpoint Configuration Manager is a systems management software product by Microsoft for managing large groups of Windows-based computer systems. Setting up PC and CSUCCESS iPad for Students.Setting up PC and Mac for Faculty and Staff.Software for Faculty and Staff University Computers.Software Request for Computer Labs and Classrooms.Software Installed on University Computers.Information Technology Consultants (ITCs).
0 Comments
Leave a Reply. |